Chip Racks for ProGen 80's. Discuss Chip Racks for ProGen 80's, on ChipTalk.net the place to go for your Poker chips and gambling tips. Read it in Poker Gear General.
Has anyone found chip racks that will fit 20 of the Progen 80's per row? Every single chip rack that I own will only hold 19. Can anyone lead me in the right direction? Any help would be greatly appreciated.
I just grabed my chip racks and put 20 of my Progen samples in them. They fit fine and even have a touch of wiggle room. I stacked the 20 progens and they were right at 2 3/4 inches or 7 cm high.
Measured the gap in the chip racks, it measures about 70.5 mm. As far as where I got them, I ordered them w/ a 1000 chip acrylic case on ebay a couple years ago. I'll try to do a bit of research and find out who I actually got them from. I'll let you know what I find out.
Hey I saw this thread and wanted to let you know that I bought the racks (link below) from Spinnetti's and they fit 20 Progens chips in a row perfectly. I can get 21 of my Deadwoods in each row. They are pretty sturdy racks also. I hope that helps you out.
Hey I saw this thread and wanted to let you know that I bought the racks (link below) from Spinnetti's and they fit 20 Progens chips in a row perfectly. I can get 21 of my Deadwoods in each row. They are pretty sturdy racks also. I hope that helps you out.
I checked my ebay account and I can't figure out where I got them from. It was so long ago that I wasn't able to see the item details.
I have heard that there are some variation in progen chip widths. You may want to just measure them and contact the ebay seller above and see if they will tell you what the width on their racks are. Good luck
Hey I saw this thread and wanted to let you know that I bought the racks (link below) from Spinnetti's and they fit 20 Progens chips in a row perfectly. I can get 21 of my Deadwoods in each row. They are pretty sturdy racks also. I hope that helps you out.
Linear Mode
