Which racks for BCC's?

[jennijen55]

I have some chips on the way (woo hoo)... I've read and read through tons of threads and still don't know. LOL. Do I need 66.7 - 67.7 - Paul-son - Chipcos? Is there more than one that will do the trick? I don't want the end chips to stick up and I don't want a lot of wiggle, although these chips are new, so there shouldn't be too much of that with the right rack anyway.

Thanks for your help - I know this is a tired question.

*** Nevermind...dug a little deeper and found out that Chipcos are the way to go.

[Josh]

New BCCs? Do tell...

[jennijen55]

Now Josh - that would spoil the suspense...

[Riculus]

Chipco.

[Josh]

Originally Posted by jennijen55

Now Josh - that would spoil the suspense...

Oh no! A teaser thread disguised as a "which rack" thread!!

[jennijen55]

Originally Posted by Josh

Oh no! A teaser thread disguised as a "which rack" thread!!

I did do that, didn't I? Whoops. I can tell you that there are 610 of them coming my way to complete the set. I have 190 in my possession. Oh, and there are 8 Chipco racks joining them...

[tonypap]

Originally Posted by jennijen55

I did do that, didn't I? Whoops. I can tell you that there are 610 of them coming my way to complete the set. I have 190 in my possession. Oh, and there are 8 Chipco racks joining them...

This is worse than the ALLY commercials that tease the crap out of those poor little kids. Want a pony??!?!? ...you didn't say I coul have a REAL pony!!!

[MarkC79]

x2 for chipco racks!

[EasilyFound]

and where does one get these chipco racks?

[john]

Not sure why people say chipco for bcc. Unless my chipco rack is an odd size. The diameter of my Samurais and T-mold blanks are too big for my chipco rack. The Sam's sit about 2+ millimeters above the curved inside bottom of the rack at the bottom of the chip and t-mold bout 1/2millimeter. So each chip is kinda getting squeezed into the rack and not getting full support