converting a 200 piece clear top case into a 300 piece case - need help
converting a 200 piece clear top case into a 300 piece case - need help. Discuss converting a 200 piece clear top case into a 300 piece case - need help, on ChipTalk.net the place to go for your Poker chips and gambling tips. Read it in Poker Chip Cases.
converting a 200 piece clear top case into a 300 piece case - need help
anyone have one of these?
im wondering if some one could measure the width of the card and dice area (inside to inside) and tell me if it is the same width as the 2 chip row on either the left or right.
im trying to figure out if i could remove the card dividers and install a new one front to back to make this into a 300 piece case.
or - even easier - if someone knows of a 300 piece clear top top case with no card slots and you can point me in the right direction, that would be most appreciated.
Re: converting a 200 piece clear top case into a 300 piece case - need help
Since most manufacturers like multi-use designs, I would assume so.
However, since most people that I have seen, don't always have sets of 100 at the larger denoms.
You could use the side rails for 100, 40 each in the top and bottom section and 20 in the middle.
How does this fit your set?
__________________
1926----2007
“When it's third and ten, you can take the milk drinkers and I'll take the whiskey drinkers every time.” Max McGee.
--2007
Linear Mode
